Effect of platelet-activating factor on lipoprotein lipase and blood lipids

We investigated the effect of platelet-activating factor (PAF) and of the PAF specific antagonist CV-6209 on plasma lipid metabolism, and particularly on post-heparin plasma lipolytic activity in male Wistar rats. Lipoprotein lipase (LPL) activity was enhanced by intravenous injection of PAF before intravenous injection of heparin when the PAF dose was low (0.2 μg/kg). PAF activated hepatic triacylglycerol lipase (HTGL) activity dose-dependently. Plasma triacylglycerols (TG) significantly decreased with the activation of LPL and/or HTGL. Plasma total cholesterol (TC) and phospholipid (PL) levels decreased at a low dose of PAF (0.2 μg/kg), but increased when higher doses were used. The PAF antagonist CV-6209 partially reversed the PAF induced effects on HTGL, TC and PL. Based on a paper presented at the Third International Conference on Platelet-Activating Factor and Structurally Related Alkyl Ether Lipids, Tokyo, Japan, May 1989.     

Effects of dietary lipids on daunomycin-induced nephropathy in mice: comparison between cod liver oil and soybean oil

Although it is well known that dietary lipids affect the course of glomerulonephritis in rats and humans, the precise mechanisms involved have not been fully elucidated. The aim of this study was to investigate the effects of different types of dietary lipids (fish oil and vegetable oil) on daunomycin (DM)-induced nephropathy in mice fed on soybean oil (SO) or cod liver oil (CLO). Urinary protein excretion, serum albumin, creatinine, total cholesterol, and TG were measured, and glomerular histological changes were evaluated. Antioxidant enzymes were also measured, along with the levels of lipid peroxide, GSH, thromboxane (Tx) B_2′ and 6-keto prostaglandin F_1α in renal cortical tissue. Dietary CLO significantly reduced urinary albumin excretion and ameliorated the histological changes induced by DM. The increase of tissue lipid peroxide levels seen in SO-fed mice was suppressed in CLO-fed mice, whereas CLO-fed mice showed higher GSH levels than SO-fed mice throughout the experiment. In addition, renal tissue GSH peroxidase activity was significantly higher at 72 h after DM injection in CLO-DM mice than in SO-DM mice. Both renal cortical TxB₂ and 6-keto PGF_1α levels were significantly lower in CLO-DM mice than in SO-DM mice. These results suggest that inhibition of oxidative damage by dietary CLO played an important role in the prevention of DM nephropathy in this mouse model. The effect of CLO was closely associated with the inhibition of Tx synthesis.     

Plasma developable photoresist containing electronic excitation energy quenching system

A dry developable negative working resist composition comprised of poly(methyl isopropenyl ketone) (PMIPK) and 4-methyl-2,6-di(4′-azido-benzylidene) cyclohexanone-1 was examined. The main photochemical product formed in the resist pattern was found to be a secondary amine which crosslinks PMIPK. Post-annealing forms a hydrogen-bonded product which shows a powerful electronic excitation energy quenching effect. The quencher is more powerful than the aromatic compound arising from the azide by post-annealing only. The residual resist thickness of the negative pattern is about 80 percent of the initial thickness of the coating in spite of all the azide compound remaining in the resist coating. The obtained dry developed resist pattern has a high dry etch resistance. Etchings of Si and SiO₂ were performed by plasma and reactive ion etching, respectively.     

Change in Oxygen Content of Y2O3-Nd2O3-Doped Silicon Nitride During Firing

The oxygen content of silicon nitride with 1 mol% Y₂O₃—Nd₂O₃ additive was measured after firing to determine the compositional change during gas-pressure sintering. Oxygen content decreases from 2.5 to 0.94 wt% during firing for 4 h at 1900°C and 10-MPa pressure in N₂. This decrease in oxygen results from the release of SiO gas generated by a thermaldecomposition reaction between Si₃N₄ and SiO₂. The resultant sintered silicon nitride material contains less than 1 wt% oxygen.     

Temperature measurements of polymer melts in the heating barrel during injection molding. Part I. Temperature distribution along the screw axis in the reservoir

A new procedure has been developed to measure the temperature distribution of the polymer melts along the screw axis during injection by using a small sheath thermocouple. At the same time, the effects of molding conditions on temperature distribution has been studied. The temperature distribution of the polymer melt along the screw axis during injection can be obtained from the difference between the standard temperature profile and the temperature profile of the polymer melt with unknown and non-uniform temperature measured under the same rate of injection. The temperature of a polymer melt within a shot is not uniform. The difference between the maximum and the minimum temperature within a shot may exceed 10°C in some cases. There are two major factors which govern the effects of molding conditions on the temperature distribution of the polymer melts during injection. The first is the amount of shear heating in the metering zone. The second is the amount of heat absorbed into the polymer in the compression and feed zones.     

基于固态LTD的大容量脉冲功率电源

固态直线变压器驱动源(LTD)是新型的脉冲功率电路方法之一.其工作原理基于大量功率半导体器件的同步控制,因此它在电路结构和工作特性方面与传统的脉冲功率电源有很大不同.在此通过实验,首先验证了LTD的基本工作原理,进而试制了一台采用650个功率MOSFET的LTD系统.实验结果分别给出了超过20 kV的最高输出电压和超过3.2 kA的最高输出电流,上升时间(10％～90％)小于20 ns.在此基础上还采用少量的模块验证了双极性LTD的可行性.实验结果同时也显示了开关的导通电阻对LTD输出参数的影响和由此带来的技术问题.     

低气压等离子喷涂TiO2涂层结构的研究

本研究分析了在低气压等离子喷涂条件下,TiO_2涂层的结构受等离子弧喷涂过程中氧分解量所影响。氧分解量很大程度上依赖于离子气中氢流量的大小,此外喷涂室压力也有一定影响。而等离子弧功率和喷涂距离对TiO_2涂层的氧分解量没有多大影响。在离子气中氢流量不变的条件下,涂层中Ti_3O_5量随喷涂室压力(从100×133.322Pa至400×133.322Pa)增加而增加。     

Gaze direction based vehicle teleoperation method with omnidirectional image stabilization and automatic body rotation control

In robot teleoperation, a robot works as a physical agent at a remote site for a robot operator. There are mainly two tasks in robot teleoperation using camera images: environment recognition using visual information and robot control according to the recognition. In this paper, we propose a gaze direction based vehicle teleoperation method with an omnidirectional image stabilization and an automatic body rotation control. In the proposed method, we manage above two tasks in the same manner that are usually treated separately. This method is an intuitive vehicle teleoperation method where an operator do not need to have concern about vehicle body orientations and can absorb differences of vehicle driving mechanisms. That is, this method frees an operator from being bothered from controlling a vehicle and the operator can concentrate on where he/she intends to go. This method mainly consists of two technologies: an omnidirectional image stabilization technology and automatic body rotation control. The conducted experiments show effectiveness of the proposed method.     

Null controllability with vanishing energy for discrete-time systems

In this paper null controllability with vanishing energy for discrete-time systems is considered. As in the case of continuous time systems necessary and sufficient conditions in terms of an algebraic Riccati equation are given. Then necessary and sufficient conditions involving the eigenvalues of the state matrix are given. Reachability and controllability with vanishing energy are also considered and necessary and sufficient conditions for them are given. Finally applications to sampled-data systems, systems with impulse control and periodic systems are discussed.     

High‐pixel‐rate grating‐light‐valve laser projector

Abstract— A high‐pixel‐rate, high‐contrast (30,000:1) wide‐color‐gamut grating‐light‐valve laser projector is reported. A new optical engine enabling high‐frame‐rate (240 Hz) scan projection is employed. Panoramic wide‐angle‐scan projection with a 64:9 aspect ratio was also developed. Speckle noise is eliminated using a simple but highly efficient technique. The optical throughput efficiency of the grating‐light‐valve laser projector is reviewed.